Any action contemplated regarding increasing the ventilation in the laser room?  <br><br><div class="gmail_quote">On Thu, Mar 3, 2011 at 2:54 PM, jim <span dir="ltr"><<a href="mailto:jim@systemateka.com">jim@systemateka.com</a>></span> wrote:<br>

<blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex;"><br>
    pipe now runs from the sub-panel to the room in<br>
which the laser cutter sits. the next step is to<br>
determine what receptacles are needed.<br>
    i recall that 20 Amps is needed for the laser<br>
cutter itself as well as for some other stuff that<br>
goes with it and have set things up for a dedicated<br>
circuit to supply that and only that.<br>
    what receptacle configuration is needed? easiest<br>
for me is to bring pipe down to a point below the<br>
bottom of the "window" and put a single gang duplex<br>
there. you'd use power strips if there are several<br>
ancillary devices.<br>
    's okay? other?<br>
<br>
<br>
<br>
<br>
<br>
<br>
<br>
_______________________________________________<br>
Noisebridge-discuss mailing list<br>
<a href="mailto:Noisebridge-discuss@lists.noisebridge.net">Noisebridge-discuss@lists.noisebridge.net</a><br>
<a href="https://www.noisebridge.net/mailman/listinfo/noisebridge-discuss" target="_blank">https://www.noisebridge.net/mailman/listinfo/noisebridge-discuss</a><br>
</blockquote></div><br><br clear="all"><br>-- <br>Ken Adler <br>510-290-5806 (cell)<br><a href="mailto:Ken@adler.net">Ken@adler.net</a> <br>----<br> <br>