<div dir="ltr"><div><div><br></div><div>Kashif V, a new philanthropist who uses the ff creator, brought that CTC machine in.  On that machine, the Atmel 8u2 didn't show up as a tty connecting USB to a PC.  Instead, it looked like it was DFU mode when I saw it, which is good and bad since it's nice to see a more evolved usb device yet it doesn't just show up as a printer device or a external storage device.  Try connected it with the SD card seated and look for ext. storage device to dump your x3g files into. Otherwise, perhaps there are some drivers for this brand printer.<br> <br></div>In any case, *always* use SD cards with these machines for reliable prints, and to untether the PC and allow it to be used for other purposes during prints..  Especially since there are two printers now.  They can both be connected to the PC for 'live control' and setup, but run full prints from the SD cards. The SD card slot for these models is on the right side of the machine. <br><br></div>I used a programmer to grab a copy of the creator firmware so I can look for something else that will work with mightyboard clone and atmega1280/2560  <br><div><br><br></div><div>regards,<br></div><div class="gmail_extra"><br></div><div class="gmail_extra">r miloh alexander<br></div></div>