[Noisebridge-discuss] Bathroom 1.0's sink
girlgeek at wt.net
Thu Jan 20 20:54:37 UTC 2011
Things You'll Need:
* Measuring tape
* 2 x 10 inch wood block
* Piece of water-resistant drywall
* Pipe wrench
Measure 30 or 38 inches, depending on your preference, from the
Then mark the wall, locate the studs and cut out a 16 x 16 inch
piece of wallboard. Install a 2 x 10 inch block of wood between
the studs by toenailing screws into studs. Make sure block is
flush with the front edge of the studs.
Repair the hole in the wall with a piece of water-resistant
drywall. Cut out for water supply lines and drain line. Place the
mounting plate on the wall, and mark holes with a drill.
Install faucet, drain and pop-up assemblies on the sink. Following
manufacturer's recommendations, attach mounting plate to the wall
onto the block installed earlier. Check that plate is level before
Set sink onto mounting bracket, and attach with anchor
bolts. Attach the trap to the drain stub from the wall, and attach
shut-off valves to water supply lines. If a trim piece is included
with the sink to hide the pipes, install it now.
Open shut-off valves. Check for leaks. Tighten any fittings to
stop leaks, if you detect any. If legs for under the front of the
sink are included, install them per manufacturer instructions now.
Read more: How to Install a Wall Hung Sink | eHow.com
On 1/20/2011 10:09 AM, Albert Sweigart wrote:
> The sink in the old bathroom seems to be coming off of the wall. Does
> anyone know how to re-secure it in a non-duct tape way?
> Bathroom 2.0's sink is doing fine and dandy.
> Noisebridge-discuss mailing list
> Noisebridge-discuss at lists.noisebridge.net
> No virus found in this message.
> Checked by AVG - www.avg.com
> Version: 10.0.1191 / Virus Database: 1435/3392 - Release Date: 01/20/11
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the Noisebridge-discuss