[Noisebridge-discuss] [dorkbotsf-blabber] MCU > 80MHz, low pincount, power saving?
tlalexander at gmail.com
Sat Nov 12 22:06:29 UTC 2011
Oh also Arduino is launching an official Arduino board based on the SAM3!
So it would be nice hardware for prototyping.
On Nov 11, 2011 4:33 PM, "Taylor Alexander" <tlalexander at gmail.com> wrote:
> I'm partial to the Atmel SAM3 line.
> The SAM3S16C meets some of your requirements, and they're excellent chips:
> Bonus is that if you're used to AVR datasheets, the SAM3 datasheets are
> similar (just, you know, over 1000 pages).
> On Fri, Nov 11, 2011 at 3:42 PM, Andy Isaacson <adi at hexapodia.org> wrote:
>> On Fri, Nov 11, 2011 at 03:28:10PM -0800, Joe Grand wrote:
>> > Check out Parallax's Propeller. May be too expensive depending on what
>> you're doing, but it meets the specs (except DMA):
>> > http://www.parallax.com/propeller/
>> > I used one in my Laser Range Finder
>> > (http://www.grandideastudio.com/portfolio/laser-range-finder/) It was
>> > a bit of a learning curve, but ultimately very powerful and cool.
>> @scanlime also used a Propeller for a similar scale project:
>> Not too much there about the GPIOs, but I found the discussion of system
>> architecture for high speed IO very enlightening.
>> Noisebridge-discuss mailing list
>> Noisebridge-discuss at lists.noisebridge.net
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the Noisebridge-discuss