[Noisebridge-discuss] payphone at gate
jof at thejof.com
Thu Apr 12 00:27:34 UTC 2012
On Wed, Apr 11, 2012 at 5:03 PM, Nicholas Granado <ngranado at gmail.com> wrote:
> that's a lot of time and effort to run conduit like that, i think we could
> achieve the same effect by moving the cables higher on the wall. Asheem and
> I ran that blue cable down to the gate a couple of months ago (there should
> be sufficient slack in the cable to move it up), and it was a real pain to
> get the cable all run.
> i would suggest that anyone attempting to repair the cable to unplug the
> minotaur side before soldering anything, that way there's no crossing of any
> cables. i also have a butane powered soldering iron if that would help,
> although i think rj45 connectors + crimps + a RJ45 cable joiner should do
> the trick and would be far more safe.
Perhaps we ought to put in some electrical precautions on the Minotaur side.
I really like that computer and would hate to see anything happen to it.
How about some diodes or loading coils?
I assume this talks RS-232?
> On Wed, Apr 11, 2012 at 3:49 PM, Ben Kochie <superq at gmail.com> wrote:
>> Yea, I have a bunch of EMT and flex conduit. I might go measure
>> things up at the gate and get some ridged (thick walled) conduit
>> On Wed, Apr 11, 2012 at 15:07, Martin Bogomolni <martinbogo at gmail.com>
>> > Depending on how things are wired, we could add some relatively
>> > inexpensive metal conduit pipe from the door to wherever the wire
>> > enters the wall to go upstairs.
>> > Barring a hacksaw, it would make it much harder to cut the wires inside.
>> > -M
>> > _______________________________________________
>> > Noisebridge-discuss mailing list
>> > Noisebridge-discuss at lists.noisebridge.net
>> > https://www.noisebridge.net/mailman/listinfo/noisebridge-discuss
>> Noisebridge-discuss mailing list
>> Noisebridge-discuss at lists.noisebridge.net
> Noisebridge-discuss mailing list
> Noisebridge-discuss at lists.noisebridge.net
More information about the Noisebridge-discuss