[Noisebridge-discuss] Creating a NoiseKey switch

Martin Bogomolni martinbogo at gmail.com
Sat Feb 4 17:15:50 UTC 2012

Yep, on day one of the post.    With a friend, I found a spring-loaded
switch box at Granger's that accepts standard keyways.  I bought one,
and will pin it to match the NB key for the open house week during
SxSW.   Should be fun!


On Sat, Feb 4, 2012 at 4:36 AM, Brink of Complexity
<brink.0x3f at gmail.com> wrote:
> Martin,
> Have you found anything of the sort yet? If not, I don't think it's beyond possibility to make one. :)
> AFAIK, the NoiseKey is a standard SC1 (Schlage) lock. I don't have one in front of me to check right now, so I'm going from memory.  Eric and I have a metric fuckton of these, and could likely just key one to the NoiseKey... after a bit of drilling and other hackery to install a switch, that is. =P
> (In any case, it's probably easier to install the switch as a position sensor on the bolt retraction mechanism than by drilling out extra parts of the drill holes the tumblers sit in, but then again I don't know exactly what application you have in mind)
> We'll be in SF in a few days, if that helps the matter at all. ;)
> - Brink
> On Feb 1, 2012, at 8:44 PM, Martin Bogomolni wrote:
>> I'm looking for a spring loaded tumbler similar to the ones used to
>> start engines, that activate a momentary contact switch, with a keyway
>> compatible with the noisebridge key.
>> So far, my search of catalogs haven't turned up anything with a
>> compatible keyway. Any suggestions?
>> -Martin
>> _______________________________________________
>> Noisebridge-discuss mailing list
>> Noisebridge-discuss at lists.noisebridge.net
>> https://www.noisebridge.net/mailman/listinfo/noisebridge-discuss

More information about the Noisebridge-discuss mailing list