[Noisebridge-discuss] New equipment for noisebridge :)
Winston Wolff
winstonw at stratolab.com
Fri Dec 4 20:37:44 UTC 2015
Perhaps a trial period where Noisebridge hosts it for some pre-determined time and then a vote is taken to see if Noisebridge wants to keep it or not?
—Winston
Winston Wolff
tel: (917) 543 8852
web: www.stratolab.com
> On Dec 4, 2015, at 12:35 PM, Trent Robbins <robbintt at gmail.com> wrote:
>
> Injection molding is suitable for low and high run work. My chief concern is how much -noise- and -space- it takes and how that overlaps with when they want to use it. Injection molding can apparently be done at low runs on some instruments using hand-fabricated molds, which I am very interested in.
>
> T
More information about the Noisebridge-discuss
mailing list