[Noisebridge-discuss] 3d printer extruder temp

[Jean Luc Picard]

Me again.

Can someone check the printer's extruder temp?  I don't know if that's a
printer/firmware thing or a software thing, but I'm almost certain it's the
temp, as most prints-- while complete-- look like they were nuked for
15secs.  Not sure if it's too high or too low, maybe it's the filament,
IDK...symmetrical/straight shapes work just fine, but do anything else & it
starts to glop &/or drag, usually straightening out on the next layer's
pass.  Or maybe I'm throwing ONLY impossible/overshrunken designs at the
printer...

Thanks whoever redid the printer's platform weeks back-- I lost the email
address for whoever said they did it &/or I didn't thank anyone.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.noisebridge.net/pipermail/noisebridge-discuss/attachments/20150218/c963e9ed/attachment-0002.html>