[Noisebridge-discuss] Moar Laser Cutter Infos

[James Sundquist]

I actually did send a request for pricing on just that component to Full
Spectrum 6 days ago, but they have yet to respond.

That e-mail replicated below:

Picture:
https://moderndevice.com/wp-content/uploads/2012/06/fse-controller-768x1024.jpg

We're a 501c3 non-profit hackerspace in SF and we're finally fixing our
Lasercutter:

*Full Spectrum Laser 4th Generation 40W CO2 Laser Engraver - Deluxe Model
<https://noisebridge.net/wiki/Lasercutter/V4_Full_Spectrum_Laser_40W>*

Our wiki page for it is found here:

https://noisebridge.net/wiki/Lasercutter

Please advise on availability and cost of a replacement board.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.noisebridge.net/pipermail/noisebridge-discuss/attachments/20151111/a7169f69/attachment-0003.html>