[Noisebridge-discuss] Drill press vise
David Perlman
omgoleus at gmail.com
Sun Oct 23 17:54:09 UTC 2016
Hello all, I am new to Noisebridge, been there a few times and met some of you.
I decided to start by repairing the drill press X-Y vise that was labeled “repair needed”. Went well up to the point where I needed to drill some holes in the vise jaw bed and it was too large for the small drill press in the shop there.
Does anyone have any good suggestion for where I could use a full-size drill press, briefly?
Thanks!
-David
More information about the Noisebridge-discuss
mailing list