[Noisebridge-discuss] Adopt an Ubertooth One (sans parts) PCB?

[miloh]

i'll assemble it and add it to our devtest board library with an nb
sticker on it, ok?

On Thu, May 26, 2011 at 2:00 PM, Tymm Twillman <tymmothy at gmail.com> wrote:
> I got in on the kickstarter for this bluetooth sniffer board, cuz I think
> it's a great project... and received my (bare) PCB from it.  Truth is
> though, I'm never going to build / use it.
> http://ubertooth.sourceforge.net/hardware/one/
> hoping someone would like it / build it / use it -- prefer if you're someone
> who has experience (and success) with fine pitch SMD soldering* and are ok
> spending $$$ on parts (the PCB is actually just a small piece of the
> cost)... docs / parts lists available from link above...
> -Tymm
> * looks like mostly 0603 with some 0402, plus fine pitch tqfp and some qfn
> w/heatsink pad.  so difficult, probably best  done with hotplate... but not
> BGA difficult.  Comes with paste stencil.
> _______________________________________________
> Noisebridge-discuss mailing list
> Noisebridge-discuss at lists.noisebridge.net
> https://www.noisebridge.net/mailman/listinfo/noisebridge-discuss
>
>