[Noisebridge-discuss] Can someone fix the 3D printer?

[Jean Luc Picard]

Someone found some high-temp tape & tried to resurface the platform but did
so by having me hold it straight then he tried pasting it while it was
still an the roll.  There are air bubbles I couldn't get out & it ruins the
print (warps even w/ raft support).

I'm leaving the city as I'm writing this & the other guy I think was just
here for business so can someone more experienced resurface it then
reflatten the platform from underneath in jog mode?  Tape should be on the
table or on the shelf next to it.

Sorry to be involved in a massacre.  To be fair, there wasn't much of a
layer to begin with beforehand, plenty of tears that worked hundreds of
layers deep into prints...
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.noisebridge.net/pipermail/noisebridge-discuss/attachments/20150123/a92a460e/attachment-0002.html>