[Noisebridge-discuss] Can someone fix the 3D printer?
Torrie Fischer
tdfischer at hackerbots.net
Fri Jan 23 21:48:19 UTC 2015
One should be able to simply peel off the tape, or just pop the bubbles with a
sharp pointy bit. Resurfacing a print bed isn't terribly difficult to get the
hang of; just takes a few tries :)
On Friday, January 23, 2015 01:38:45 PM Jean Luc Picard wrote:
> Someone found some high-temp tape & tried to resurface the platform but did
> so by having me hold it straight then he tried pasting it while it was
> still an the roll. There are air bubbles I couldn't get out & it ruins the
> print (warps even w/ raft support).
>
> I'm leaving the city as I'm writing this & the other guy I think was just
> here for business so can someone more experienced resurface it then
> reflatten the platform from underneath in jog mode? Tape should be on the
> table or on the shelf next to it.
>
> Sorry to be involved in a massacre. To be fair, there wasn't much of a
> layer to begin with beforehand, plenty of tears that worked hundreds of
> layers deep into prints...
More information about the Noisebridge-discuss
mailing list