[Noisebridge-discuss] Network status
Jacob Appelbaum
jacob at appelbaum.net
Fri Oct 3 02:57:28 UTC 2008
Thanks to Jof and Andy, we've got an openbsd box up as the core router
and a linksys box up as our wifi router. We'll probably want to reflash
the linksys at some point to run some free firmware (Qos, etc).
Currently it's working fine. The soekris has a cloned MAC address
because Andy's laptop was the first to use the cable modem.
Here's the configuration information for the wifi:
eth1 Link encap:Ethernet HWaddr 00:DE:AD:C0:FF:EE
inet addr:172.30.0.200 Bcast:172.30.1.255 Mask:255.255.254.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:1557 errors:0 dropped:0 overruns:0 frame:0
TX packets:1142 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:6246582 (5.9 MiB) TX bytes:1264179 (1.2 MiB)
Interrupt:50 Base address:0x8000 Memory:a0202000-a0202fff
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use
Iface
172.30.0.0 0.0.0.0 255.255.254.0 U 0 0 0 eth1
169.254.0.0 0.0.0.0 255.255.0.0 U 1000 0 0 eth1
0.0.0.0 172.30.0.1 0.0.0.0 UG 0 0 0 eth1
eth1 IEEE 802.11g ESSID:"noisebridge"
Mode:Managed Frequency:2.412 GHz Access Point: 00:18:F8:F9:32:ED
Bit Rate:54 Mb/s Tx-Power=20 dBm Sensitivity=8/0
Retry limit:7 RTS thr:off Fragment thr:off
Power Management:off
Link Quality=88/100 Signal level=-41 dBm Noise level=-91 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:4
Best,
Jake
More information about the Noisebridge-discuss
mailing list