[Noisebridge-discuss] laser cutter
jim
jim at systemateka.com
Thu Mar 3 22:54:18 UTC 2011
pipe now runs from the sub-panel to the room in
which the laser cutter sits. the next step is to
determine what receptacles are needed.
i recall that 20 Amps is needed for the laser
cutter itself as well as for some other stuff that
goes with it and have set things up for a dedicated
circuit to supply that and only that.
what receptacle configuration is needed? easiest
for me is to bring pipe down to a point below the
bottom of the "window" and put a single gang duplex
there. you'd use power strips if there are several
ancillary devices.
's okay? other?
More information about the Noisebridge-discuss
mailing list