[Noisebridge-discuss] laser cutter

[Ken Adler]

Any action contemplated regarding increasing the ventilation in the laser
room?

On Thu, Mar 3, 2011 at 2:54 PM, jim <jim at systemateka.com> wrote:

>
>    pipe now runs from the sub-panel to the room in
> which the laser cutter sits. the next step is to
> determine what receptacles are needed.
>    i recall that 20 Amps is needed for the laser
> cutter itself as well as for some other stuff that
> goes with it and have set things up for a dedicated
> circuit to supply that and only that.
>    what receptacle configuration is needed? easiest
> for me is to bring pipe down to a point below the
> bottom of the "window" and put a single gang duplex
> there. you'd use power strips if there are several
> ancillary devices.
>    's okay? other?
>
>
>
>
>
>
>
> _______________________________________________
> Noisebridge-discuss mailing list
> Noisebridge-discuss at lists.noisebridge.net
> https://www.noisebridge.net/mailman/listinfo/noisebridge-discuss
>



-- 
Ken Adler
510-290-5806 (cell)
Ken at adler.net
----
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.noisebridge.net/pipermail/noisebridge-discuss/attachments/20110303/b31e9e55/attachment-0003.html>